Our Process

1. Remove Items

Anything that looks personal will be kept for you to sort through. We do ask that you try to remove anything personal and private from the vehicle before we begin.

2. Vacuum

We do a thorough vacuuming, using compressed air and a drill brush to help loosen the debris in the carpet and get debris from tight areas.

3. Shampoo and Extract

We pretreat the seats and carpet to break down the dirt, then rinse the dirt and cleaner our of the seats using our extractor.

4. Clean Plastics and Leather

We use detail brushes and steam to clean all the nooks and crannies around your plastics and seats.

5. Glass

We clean all clear surfaces surfaces. Your windshield, door glass, back glass, rearview mirror, vanity mirrors, gauges and remove any streaks on your infotainment center.

6. Pre Rinse

Now to the outside. We need to remove as much dirt from the paint as we can. We use a lower powered pressure washer to blast away as much dirt as we can.

7. Wheels

We use a variety of brushes to get the face and inner wheel. We also attack the fenders while we are there.

8. Pre Soak

Foaming up your vehicle helps loosen the dirt. As the foam drips off the paint, it carries most of the dirt with it. Plus, we think it looks cool.

9. Mid Rinse

Now that the foam has had time to loosen up the dirt, We rinse off the vehicle again to wash as much away as possible.

10. Hand Wash

We gently was your vehicle with microfiber wash mitts. We use super soft detail brushes to get around emblems and other small areas.

11. Post Wash Rinse

Now that everything has been agitated, its time to rinse again. This will reveal clean paint that was hiding under all that grime.

12. Dry

Blowing off the water gets the majority off, then we come back with a huge microfiber drying towel and pull it across the surface. We do not add any pressure, just the weight of the towel.

13. Clay Bar

Using a detail spray as lubricant, we clay bar your paint to remove all those embedded contaminants. This leaves behind paint that feels as smooth as glass. If your paint feels rough, it probably needs this.

14. Outside Glass

After clay baring is the best time to clean the glass, as all of the contaminants are gone and all that’s left are the smudges from the claying process. So we spray and wipe down the glass to give you a crystal clear view of the road ahead.

15. Compound and Polish

This is a big step. We go over every inch of your car removing every scratch we see. We start with the interior plastics such as your center console gauge cluster and move to the outside where we go over the paint, rims, and exhaust tips. After polishing, we wipe everything down with a prep spray to get ready for a coating.

16. Coatings

Everything gets a coating. If there is a form of protection for it, we apply it. Leather, plastics, cloth, paint, rims and glass. Some of the coatings require a second coat. All should wait at least 48 hours before getting wet.

17. Dress Tires

Finally, we give the tires a shine. This will not cause sling as the dressing is dry to the touch moments after applying.

18. Checklist

Finally, we go back around the vehicle and looks for areas we may have missed or can improve on and take care of them before presenting the vehicle to you.